Table of Contents
Advertisement
ZyWALL 2 Series User's Guide
The following table describes the fields in this menu.
FIELD
Active
Press [SPACE BAR] and then [ENTER] to select either Yes to enable the
AT strings or No to disable them.
Set 1-6:
Enter an Expect string to match. After matching the Expect string, the
Expect
ZyWALL returns the string in the Send field.
Set 1-6:
Enter a string to send out after the Expect string is matched.
Send
23.9 Remote Node Filter
Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the ZyWALL to prevent certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field.
Please refer to the Filters chapter for more information on defining the filters.
23-12
Menu 11.4 - Remote Node Script
Active= No
Set 1:
Expect=
Send=
Set 2:
Expect=
Send=
Set 3:
Expect=
Send=
Set 4:
Expect=
Send=
Enter here to CONFIRM or ESC to CANCEL:
Figure 23-8 Menu 11.4: Remote Node Script
Table 23-7 Menu 11.4: Remote Node Script
DESCRIPTION
Set 5:
Expect=
Send=
Set 6:
Expect=
Send=
WAN and Dial Backup Setup
EXAMPLE
No
(default)
0.0.0.0
Advertisement
Table of Contents
