This chapter describes how to configure the WAN using menu 2 and dial-backup using menus 2.1
23.1 Introduction to WAN
This chapter explains how to configure settings for your WAN port.
From the main menu, enter 2 to open menu 2.
The following table describes the fields in this screen.
FIELD
MAC Address
Assigned By
Press [SPACE BAR] and then [ENTER] to choose one of two methods
to assign a MAC Address. Choose Factory Default to select the factory
assigned default MAC Address. Choose IP address attached on LAN
to use the MAC Address of that workstation whose IP you give in the
following field.
WAN and Dial Backup Setup
WAN and Dial Backup Setup
Menu 2 - WAN Setup
MAC Address:
Assigned By= Factory default
IP Address= N/A
Dial-Backup:
Active= No
Phone Number=
Port Speed= 9600
AT Command String:
Init=
Edit Advanced Setup= No
Press ENTER to Confirm or ESC to Cancel:
Figure 23-1 MAC Address Cloning in WAN Setup
Table 23-1 MAC Address Cloning in WAN Setup
DESCRIPTION
ZyWALL 2 Series User's Guide
Chapter 23
EXAMPLE
IP address
attached on
and 11.1.
LAN
23-1