Table of Contents
Advertisement
LABEL
User Name
Password
Retype to Confirm
Nailed-up
Connection
Idle Timeout
PPTP Configuration
My IP Address
My IP Subnet Mask
Server IP Address
Connection ID/Name
Apply
Reset
6.6
Configuring WAN IP
To change your ZyWALL's WAN IP settings, click WAN, then the WAN IP tab. This screen varies
according to the type of encapsulation you select.
If your ISP did not assign you a fixed IP address, click Get automatically from ISP (Default);otherwise
click Use fixed IP Address and enter the IP address in the following field.
When Network Address Translation is set to Full Feature, but there is no NAT rule
configured, the warning message "Warning! No NAT rule configured in system"
WAN Screens
Table 6-6 PPTP Encapsulation
Type the user name given to you by your ISP.
Type the password associated with the User Name above.
Type your password again to make sure that you have entered is correctly.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the ZyWALL
automatically disconnects from the PPTP server.
Type the (static) IP address assigned to you by your ISP.
Your ZyWALL will automatically calculate the subnet mask based on the IP
address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the ZyWALL.
Type the IP address of the PPTP server.
Type your identification name for the PPTP server.
Click Apply to save your changes back to the ZyWALL.
Click Reset to begin configuring this screen afresh.
appears in the status bar.
ZyWALL 2 Series User's Guide
DESCRIPTION
6-9
Advertisement
Table of Contents
