Resetting The Zywall; Figure 2-2 Replace Certificate Screen - ZyXEL Communications ZYWALL2 ET 2WE User Manual

ZyWALL 2 Series User's Guide
Step 6.
Click Apply in the Replace Certificate screen to create a certificate using your ZyWALL's
MAC address that will be specific to this device. This feature is not available on the ZyWALL
2WE.
Step 7. You should now see the MAIN MENU screen (see Figure 2-4).
The management session automatically times out when the time period set in the
Administrator Inactivity Timer field expires (default five minutes). Simply log back into
2.3

Resetting the ZyWALL

If you forget your password or cannot access the SMT menu, you will need to reload the factory-default
configuration file or use the RESET button located on the rear panel of the ZyWALL. Uploading this
configuration file replaces the current configuration file with the factory-default configuration file. This
means that you will lose all configurations that you had previously and the speed of the console port will be
reset to the default of 9600bps with 8 data bit, no parity, one stop bit and flow control set to none. The
password will be reset to "1234", also.
2.3.1 Procedure To Use The Reset Button
Step 1. Make sure the PWR LED is on (not blinking) before you begin this procedure.
Step 2. Continue to hold the RESET button. If the PWR LED begins to blink, the defaults have been
restored and the ZyWALL restarts.
2-2

Figure 2-2 Replace Certificate Screen

the ZyWALL if this happens to you.
Introducing the Web Configurator