Table of Contents
Advertisement
Table 23-4 Advanced WAN Port Setup: Call Control Parameters
FIELD
Call Control
Dial Timeout
(sec)
Retry Count
Retry Interval
(sec)
Drop Timeout
(sec)
Call Back Delay
(sec)
23.5 Remote Node Profile (Backup ISP)
Enter 2 in Menu 11 Remote Node Setup to open Menu 11.1 Remote Node Profile (Backup ISP) (shown
below) and configure the setup for your Dial Backup port connection.
WAN and Dial Backup Setup
Enter a number of seconds for the ZyWALL to keep trying to set
up an outgoing call before timing out (stopping). The ZyWALL
times out and stops if it cannot set up an outgoing call within the
timeout value.
Enter a number of times for the ZyWALL to retry a busy or no-
answer phone number before blacklisting the number.
Enter a number of seconds for the ZyWALL to wait before trying
another call after a call has failed. This applies before a phone
number is blacklisted.
Enter a number of seconds for the ZyWALL to wait before
dropping the DTR signal if it does not receive a positive
disconnect confirmation.
Enter a number of seconds for the ZyWALL to wait between
dropping a callback request call and dialing the co-responding
callback call.
DESCRIPTION
ZyWALL 2 Series User's Guide
DEFAULT
60 seconds
0 to disable
the blacklist
control
20 seconds
15 seconds
23-5
Advertisement
Table of Contents
