Using The Ftp Command From The Dos Prompt; Figure 17-2 Ftp Session Example; Table 17-2 General Commands For Third Party Ftp Clients - ZyXEL Communications ZYAIR G-1000 User Manual

17.2.2 Using the FTP command from the DOS Prompt

Step 1.
Launch the FTP client on your computer.
Step 2.
Enter "open" and the IP address of your ZyAIR.
Step 3. Press [ENTER] when prompted for a username.
Step 4. Enter "root" and your SMT password as requested. The default is 1234.
Step 5.
Enter "bin" to set transfer mode to binary.
Step 6. Use "get" to transfer files from the ZyAIR to the computer, for example, "get rom-0 config.rom"
transfers the configuration file on the ZyAIR to your computer and renames it "config.rom". See
earlier in this chapter for more information on filename conventions.
Step 7. Enter "quit" to exit the FTP prompt.
331 Enter PASS command
Password:
230 Logged in
ftp> bin
200 Type I OK
ftp> get rom-0 zyxel.rom
200 Port command okay
150 Opening data connection for STOR ras
226 File received OK
ftp: 327680 bytes sent in 1.10Seconds 297.89Kbytes/sec.
ftp> quit
The following table describes some of the commands that you may see in third party FTP clients.

Table 17-2 General Commands for Third Party FTP Clients

COMMAND
Host Address
Login Type
Transfer Type
Firmware and Configuraiton File Maintenance

Figure 17-2 FTP Session Example

Enter the address of the host server.
Anonymous.
This is when a user I.D. and password is automatically supplied to the server for
anonymous access. Anonymous logins will work only if your ISP or service
administrator has enabled this option.
Normal.
The server requires a unique User ID and Password to login.
Transfer files in either ASCII (plain text format) or in binary mode.
ZyAIR G-1000 Access Point User's Guide
DESCRIPTION
17-3