Rep Messages - Cisco 3845 - Security Bundle Router Manual

Chapter 2 Messages and Recovery Procedures
Error Message QOSMGR-4-VLAN_LABEL_EXCEED_MAX: Exceeded a maximum of active vlan
classifications.

REP Messages

Error Message REP-3-INVALIDPKT: received invalid pkt: [chars]
Explanation
information about the invalid packet.
Error Message REP-3-NOPPPROC: [traceback] Failed to create REP LSL Fast Hello Process
Explanation
Status Layer (LSL) age timer is set to more than 3 seconds.
Error Message REP-4-LINKSTATUS: [chars] (segment [dec]) is [chars]
Error Message REP-5-PREEMPTIONFAIL: can not perform preemption on segment [dec] due
to [char]
OL-23408-01
Explanation The number of VLAN classifications required for all attached per-port, per-VLAN QoS
policies exceeds the maximum number of VLAN classifications that are supported by this hardware.
Reconfigure the attached per-port, per-vlan QoS policies to reduce the number
Recommended Action
of VLANs used for classification.
The switch has received an invalid Resilient Ethernet Protocol (REP) packet. [chars] is
Recommended Action Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still need assistance, open a case with the TAC, or provide
your Cisco technical support representative with your information. For more information about these
online tools and about contacting Cisco, see the
page 1-5.
The switch cannot exchange hello packets with its REP neighbors because the Link
Reload the switch.
Recommended Action
Explanation The REP-interface link status has changed. The first [chars] is the interface name. The
[dec] is the REP segment number of the interface, and the second [chars] is the new link status.
Recommended Action No action is required.
Explanation The REP preempt operation failed. This could be due to an invalid port ID or a
neighbor_offset number specified with the rep block port interface configuration command. This
could also be caused by entering the rep block port preferred interface configuration command if
there is no REP port configured with the preferred keyword. [dec] is the segment number, and
[char] is the reason for the failure.
Correct the configuration. Run REP manual preemption on the primary edge
Recommended Action
port by using the rep preempt segment command.
Cisco ME 3400E, ME 3400, and ME 2400 Ethernet Access Switch System Message Guide
"Error Message Traceback Reports" section on
REP Messages
2-55