Remote Switch Update Configuration Example - 3Com 7757 Configuration Manual

870 C 80: D
HAPTER EVICE
Remote Switch
Update Configuration
Example
M
ANAGEMENT
Table 689 Display the operating status of the device management
Operation
Display the APP to be
adopted at reboot
Display the module type and
operating status of each
board
Display information about
environment used by a switch
Display the operating status
of the built-in fan
Display the usage of s switch
Display memory usage of a
switch
Display the operating status
of the power supply
Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP
server to the Flash memory of the switch to remotely update the switch software
by using the device management commands through CLI.
The switch acts as the FTP client, and the remote PC serves as both the
configuration PC and the FTP server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name and password are switch and hello
■
respectively. Authorize the user with the read-write right of the Switch
directory on the PC.
Make appropriate configuration so that the IP address of a VLAN interface on
■
the switch is 1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the
PC is reachable to each other.
The host software switch.app and the BootROM file boot.btm of the switch are
stored into the directory of the switch. Use FTP to download the switch.app and
boot.btm files from the FTP server to the switch.
Network diagram
Figure 229 Network diagram of FTP configuration
2.2.2.2
PC
Configuration procedure
1 Configure the following FTP server-related parameters on the PC: an FTP user with
the username and password as switch and hello respectively, and specify the
Command
display boot-loader
display device [ detail | [ shelf
shelf-no ] [ frame frame-no ] [ slot
slot-number ] ]
display environment
display fan [ fan-id ]
display cpu [ slot slot-number ]
display memory [ slot slot-number
| limit ]
display power [ power-id ]
1.1.1.1
Network
Switch
Description
You can execute the
display command in
any view.