Configuration Example - 3Com 7757 Configuration Manual

916 C 82: RRPP C
HAPTER
Assistant Edge Node

Configuration Example

Configuration
Example
Single Ring Network
Configuration Example
ONFIGURATION
Before creating an RRPP ring, you must create a control VLAN.
■
RRPP and loopback test functions are mutually exclusive. You must disenable
■
the loopback test on the primary/secondary port of the master/transit node and
the common/edge port of the edge node.
When deleting an RRPP domain by using the undo rrpp domain command,
■
make sure no RRPP ring exists in the RRPP domain.
The ring ID must be unique in the same RRPP domain.
■
Network requirements
Define the switch as a node in RRPP domain 1.
■
Define VLAN 4092 as the control VLAN
■
Define the switch as a transit node in primary ring 1 in RRPP domain 1, the port
■
GigabitEthernet2/0/1 as the primary port, the port GigabitEthernet2/0/2 as the
secondary port.
Define the switch as an assistant edge node on subring 2 in the RRPP domain
■
1, the port GigabitEthernet2/0/2 as the common port, and the port
GigabitEthernet2/0/4 as the edge port.
Configuration procedure
c
CAUTION: Make sure that the switch ports connecting the Ethernet rings have
been configured as trunk ports. All ports allow data VLAN packets to pass. And
STP has been disenabled on all the ports connecting the Ethernet rings.
<SW7750> system-view
[SW7750] rrpp domain 1
[SW7750-rrpp-domain-1] control-vlan 4092
[SW7750-rrpp-domain-1] ring 1 node-mode transit primary-port Gigabit
Ethernet2/0/1 secondary-port GigabitEthernet2/0/2 level 0
[SW7750-rrpp-domain-1] ring 2 node-mode assistant-edge common-port G
igabitEthernet 2/0/2 edge-port GigabitEthernet 2/0/4
[SW7750-rrpp-domain-1] ring 1 enable
[SW7750-rrpp-domain-1] ring 2 enable
[SW7750-rrpp-domain-1] quit
[SW7750] rrpp enable
[SW7750] display rrpp brief
[SW7750] display rrpp verbose domain 1
[SW7750] display rrpp statistics domain 1
Network requirements
Switch A, Switch B, Switch C and Switch D constitute RRPP domain 1
■
VLAN 4092 is the control VLAN of RRPP domain 1
■
Switch A, Switch B, Switch C and Switch D constitute primary ring 1
■
Switch A serves as the master node of the primary ring, its
■
GigabitEthernet2/0/1 is the primary port, and GigabitEthernet2/0/2 is the
secondary port