3Com 7757 Configuration Manual page 862

862 C 80: D
HAPTER EVICE
Restarting the Ethernet
Switch
n
Rebooting a Module of
Ethernet Switch
Scheduling a Reboot on
the Switch
M
ANAGEMENT
Table 674 Device management configuration tasks
Operation
Update the BootROM
Upgrade BootROM along with
the upgrade of ARP
Set module temperature
threshold
Enable/disable RDRAM
Enable system load sharing
Identifying and Diagnosing
Pluggable Transceivers
You can perform the following operation in user view when the switch is in
trouble or needs to be restarted.
Table 675 Restart the Ethernet switch
Operation
Restart the Ethernet switch
When rebooting, the system checks whether there is any configuration change. If
there is, it prompts you to indicate whether or not to proceed. This prevents you
from losing your original configuration due to oblivion after system reboot.
It would be necessary to reset a module of Ethernet switch when failure occurs.
Table 676 Reset a card
Operation
Reset a module of Ethernet
switch
The value of slot-number ranges with products:
Switch 7754: 0 to 3
■
Switch 7757: 0 to 6
■
Switch 7758: 0 to 7
■
The value 0 indicates to reset the Fabric, equivalent to resetting the switch system.
After you schedule a reboot on the switch, the switch will reboot at the specified
time.
Table 677 Schedule a reboot on the switch
Operation
Schedule a reboot on the switch, and
set the reboot date and time
Description
Optional
Optional
Optional
Optional
Optional
Optional
Command
reboot
Command
reboot [ slot slot-number ]
Command
schedule reboot at hh:mm
[ yyyy/mm/dd ]
Related section
"Updating the BootROM" on
page 863
"Upgrading BootROM along with
the Upgrade of ARP" on page 863
"Setting Module Temperature
Threshold" on page 864
"Enabling/Disabling RDRAM" on
page 864
"Enabling System Load Sharing"
on page 864
"Identifying and Diagnosing
Pluggable Transceivers" on page
865
Description
-
Description
Optional
Description
Optional