Displaying And Maintaining Aaa & Radius & Hwtacacs Information - 3Com 7757 Configuration Manual

536 C 49: AAA & RADIUS & HWTACACS C
HAPTER
Displaying and
Maintaining AAA &
RADIUS & HWTACACS
Information
ONFIGURATION
information of online users to the TACACS accounting server at intervals of this
value. Even if the server does not respond, the device does not cut down the
online user.
The interval must be a multiple of 3.
■
The setting of real-time accounting interval somewhat depends on the
■
performance of the device and the TACACS server: A shorter interval requires
higher device performance.
After the above configurations, you can execute the display commands in any
view to view the operation of AAA, RADIUS and HWTACACS and verify your
configuration.
You can use the reset command in user view to clear the corresponding statistics.
Table 425 Display AAA information
Operation
Display the configuration
information about one
specific or all ISP domains
Display the information
about user connections
Display the information
about local users
Table 426 Display and maintain RADIUS protocol information
Operation
Display the statistics about
local RADIUS authentication
server
Display the configuration
information about one
specific or all RADIUS
schemes
Display the statistics about
RADIUS packets
Display the buffered
no-response RADIUS
stop-accounting request
packets
Command
display domain [ isp-name ]
display connection [ access-type dot1x |
domain domain-name | interface
interface-type interface-number | ip ip-address
| mac mac-address | radius-scheme
radius-scheme-name | vlan vlan-id | ucibindex
ucib-index | user-name user-name ]
display local-user [ domain isp-name |
idle-cut { disable | enable } | vlan vlan-id |
service-type { ftp | lan-access | ssh | telnet |
terminal } | state { active | block } |
user-name user-name ]
Command
display local-server statistics
display radius
[ radius-scheme-name ]
display radius statistics
display
stop-accounting-buffer { radiu
s-scheme radius-scheme-name |
session-id session-id |
time-range start-time stop-time
| user-name user-name }
Description
You can
execute the
display
command in
any view
Description
You can execute the
display command in any
view