Configuring A Port-Based Vlan - 3Com 7757 Configuration Manual

Displaying VLAN
Configuration
Configuring a
Port-Based VLAN
Configuring an
Access-Port-Based VLAN
If a VLAN interface is disabled, its status is not determined by the status of its
ports.
After the configuration above, you can execute the display command in any view
to display the running status after the configuration, so as to verify the
configuration.
Table 51 Display VLAN configuration
Operation
Display the VLAN interface
information
Display the VLAN information display vlan [ vlan-id [ to
There are two ways to configure Access-port-based VLAN: one way is to configure
in VLAN view, the other way is to configure in Ethernet port view.
Follow these steps to configure the Access-port-based VLAN in VLAN view:
To do...
Enter system view
Enter VLAN view
Add an Access port to the
current VLAN
Follow these steps to configure the Access-port-based VLAN in Ethernet port view:
To do...
Enter system view
Enter Ethernet port view
Configure the port link type
as Access
Add the current Access port
to a specified VLAN
n
To add an Access port to a VLAN, make sure the VLAN already exists.

Configuring a Port-Based VLAN

Command
display interface
Vlan-interface [ vlan-id ]
vlan-id ] | all | static |
dynamic ]
Use the command...
system-view
vlan vlan-id
port interface-list
Use the command...
system-view
interface interface-type
interface-number
port link-type access
port access vlan vlan-id
97
Description
You can execute the display
command in any view.
Remarks
-
Required
If the specified VLAN does not
exist, this command be
created first creates the VLAN
before entering its view.
Required
By default, system will add all
ports to VLAN 1.
Remarks
-
-
Optional
The link type of a port is
Access by default.
Optional
By default, all Access ports
belong to VLAN 1.