3Com 7757 Configuration Manual page 845

Loading Process Using FTP Client
Loading BootROM software
■
Figure 221 Local loading using FTP client
Console port
PC
Step 1: As shown in Figure 221, connect the switch through an Ethernet port to
the FTP server, and connect the switch through the Console port to the
configuration PC.
n
You can use one computer as both configuration device and FTP server.
Step 2: Run the FTP server program on the FTP server, configure an FTP user name
and password, and copy the program file to the specified FTP directory.
Step 3: Run the HyperTerminal program on the configuration PC. Start the switch.
Then enter the Boot Menu.
At the prompt "Enter your choice(0-5):" in the Boot Menu, press <Ctrl+U>, and
then press <Enter> to enter the BootROM update menu shown below:
SRPG bootrom update menu:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):
Step 4: Enter 2 in the above menu to download the BootROM software using FTP.
Then set the following FTP-related parameters as required:
Load File name
Switch IP address
Server IP address
FTP User Name
FTP User Password
Step 5: Press <Enter>. The system displays the following information:
Are you sure you want update SRPG bootrom?Yes or No(Y/N)
Step 6: Enter Y to start file downloading or N to return to the Bootrom update
menu. If you enter Y, the system begins to download and update the program.
Upon completion, the system displays the following information:
Prepare for loading...OK!
Loading........................................done
Bootrom updating..........done!
Loading host software
■
Switch
Ethernet port
FTP Client FTP Server
:S7750.btm
:10.1.1.2
: 10.1.1.1
:7500
:abc
Local Software Loading 845