Rip Configuration Example - 3Com 7757 Configuration Manual

RIP Configuration
Example
Network requirements
As shown in Figure 70, SwitchC is connected to subnet 117.102.0.0 through an
Ethernet port. SwitchA and SwitchB are connected to networks 155.10.1.0 and
196.38.165.0 respectively through Ethernet ports. SwitchC, SwitchA and SwitchB
are interconnected through Ethernet 110.11.2.0. It is required to configure RIP
correctly to ensure the interworking between the networks connected to SwitchC,
SwitchA and SwitchB.
Network diagram
Figure 70 RIP configuration
Ethernet
Switch C
Vlan-int 4
Device Interface
Switch A Vlan-int1
Vlan-int2
Switch C Vlan-int1
Vlan-int4
Configuration procedure
n
Only the configuration related to RIP is listed below. Before the following
configuration, make sure the Ethernet link layer works normally and the IP
addresses of VLAN interfaces are configured correctly.
1 Configure SwitchA:
# Configure RIP.
<SwitchA>system-view
[SwitchA] rip
[SwitchA-rip] network 110.11.2.0
[SwitchA-rip] network 155.10.1.0
2 Configure SwitchB:
# Configure RIP.
<SwitchB>system-view
[SwitchB] rip
[SwitchB-rip] network 196.38.165.0
[SwitchB-rip] network 110.11.2.0
3 Configure SwitchC:
Vlan-int 2
Switch A
Vlan-int 1
IP address
110.11.2.1/24
155.10.1.1/24
110.11.2.3/24
117.102.0.1/16

RIP Configuration Example

Switch B
Vlan-int 3
Device Interface
Switch B Vlan-int1
Vlan-int3
299
IP address
110.11.2.2/24
196.38.165.1/24