3Com 7757 Configuration Manual page 820

820 C 75: I
HAPTER NFORMATION
n
Enabling Information
Output to the Console
C
ENTER
Table 647 Enable information output to a log host
Operation
Enable information output to
a log host
Configure the source
interface through which log
information is sent to the log
host
Define an information source
Set the format of the time
stamp
To view the debugging information of specific modules, you need to set the
information type as debug in the info-center source command, and enable
debugging for corresponding modules through the debugging command.
Table 648 lists the related configurations on the switch.
Table 648 Enable information output to the console
Operation
Enter system view
Enable the information center info-center enable
Enable information output to
the console
Define an information source
Command
info-center loghost
host-ip-addr
[ channel { channel-number |
channel-name } | facility
local-number |
language { chinese |
english } ] *
info-center loghost source
interface-type
interface-number
info-center
source { modu-name |
default }
channel { channel-number |
channel-name } [ { log | trap |
debug } * { level severity |
state state } * ]
info-center timestamp { log
| trap | debugging } { boot |
date | none }
Command
system-view
info-center console
channel { channel-number |
channel-name }
info-center
source { modu-name |
default }
channel { channel-number |
channel-name } [ { log | trap |
debug } { level severity |
state state } ]*
Description
Required
By default, the switch does
not output information to the
log host.
After you configure the switch
to output information to the
log host, the switch uses
information channel 2 by
default.
Be sure to set the correct IP
address. A loopback IP
address will cause an error
message prompting invalid
address.
Optional
Required
Optional
Description
-
Optional
By default, the information
center is enabled.
Required
By default, the switch uses
information channel 0 to
output log/debugging/trap
information to the console.
Required