Displaying Ip Routing Policy; Ip Routing Policy Configuration Example - 3Com 7757 Configuration Manual

Applying Routing Policy
to Route
Receipt/Advertisement
Displaying IP Routing
Policy
IP Routing Policy
Configuration
Example
Configuring IP Routing
Policy
routing costs of the source routing protocol, you should specify a routing cost for
the imported routes.
n
The import-route command (used to import routes) is somewhat different in
form in different routing protocol views. Refer to the import-route command
description under the required routing protocol in the command manual.
n
The filter-policy command (used to apply routing policy to route
receipt/advertisement) is somewhat different in form in different routing protocol
views. Refer to the filter-policy command description under the required routing
protocol in the command manual.
After the above configuration, execute the display command in any view to
display and verify the routing policy configuration.
Table 314 Display a route policy
Operation
Display route-policy
information
Display BGP routes that
match an AS path ACL
Display address prefix
list information
Display community list
information
Network requirements
As shown in Figure 87, Switch A communicates with Switch B using OSPF
■
protocol. Switch A's router ID is 1.1.1.1 and Switch B's is 2.2.2.2.
Configure OSPF routing process on Switch A, and configure three static routes.
■
Configure a routing policy for Switch A to filter imported static routes. In this
■
example, the routes in 20.0.0.0 and 40.0.0.0 network segments can be
imported, but those in 30.0.0.0 network segment will be filtered out.
Command
display route-policy
[ route-policy-name ]
display ip as-path-acl
[ acl-number ]
display ip ip-prefix
[ ip-prefix-name ]
display ip community-list
[ basic-comm-list-number |
adv-comm-list-number ]

Displaying IP Routing Policy

Description
You can execute the display
command in any view.
383