Port; Ethernet Port Configuration - 3Com 7757 Configuration Manual

22
Ethernet Port
Configuration
Configuring the Basic
Settings of an Ethernet
P B
ORT
Table 105 Configure the basic settings of an Ethernet port

Port

Operation
Enter system view
Enter Ethernet port view
Enable the Ethernet port
Set the description of the
Ethernet port
Set the duplex mode of the
Ethernet port
Set the speed of the Ethernet
port
Set the medium dependent
interface (MDI) attribute of
the Ethernet port
Allow jumbo frames to pass
through the Ethernet port
Use the following two tables when setting the duplex mode and rate of an
Ethernet port.
C
ASIC ONFIGURATION
Command
system-view
interface interface-type
interface-number
undo shutdown
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 |
10000 | auto }
mdi { across | auto |
normal }
jumboframe enable
[ jumboframe-value ]
Description
-
-
Optional
By default, the port is
enabled.
Use the shutdown command
to disable the port.
Optional
By default, no description is
defined for the port.
Optional
By default, the duplex mode
of the port is auto
(auto-negotiation).
Optional
By default, the speed of the
port is auto
(auto-negotiation).
Optional
Be default, the MDI attribute
of the port is auto.
Optional
By default, jumbo frames that
are larger than 1518 bytes
and smaller than 1536 bytes
are allowed to pass through
the port.