3Com 7757 Configuration Manual page 677

Configuration Procedure
of Traffic Statistics
Clearing Traffic Statistics
Information
Configuration Example
Table 547 Configure traffic statistics
Operation
Enter system view
Enter Ethernet port view
Enter QoS view
Use the ACL rules in traffic
identifying and perform traffic
statistics on the packets
matching with the ACL rules.
Display the traffic statistics.
Display all the QoS settings of
the port
acl-rule: Applied ACL rules which can be the combination of various ACL rules.
Type-A I/O Modules' way of combination is described in Table 540, and
non-type-A I/O Modules' way of combination is described in Table 541.
Table 548 Clear traffic statistics information
Operation
Enter system view
Enter Ethernet port view
Enter QoS view
Clear the statistics of the
traffic matching with the
specified ACL rules
acl-rule: Applied ACL rules which can be the combination of various ACL rules.
Type-A I/O Modules' way of combination is described in Table 540, and
non-type-A I/O Modules' way of combination is described in Table 541.
Ethernet 2/0/1 of the switch is accessed into the 10.1.1.1/24 network segment
■
Perform traffic statistics on packets from the 10.1.1.1/24 network segment
■
Configuration procedure:
<SW7750> system-view
[SW7750] acl number 2000
[SW7750-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255
[SW7750-acl-basic-2000] quit
Configuring Traffic Statistics
Command
system-view
interface interface-type
interface-number
qos
traffic-statistic { inbound |
outbound } acl-rule
[ system-index
system-index ]
traffic-statistic inbound
acl-rule [ system-index
system-index ]
display qos-interface
[ interface-type
interface-number ]
display qos-interface
[ interface-type
interface-number ] all
Command
system-view
interface interface-type
interface-number
qos
reset
traffic-statistic { inbound |
outbound } acl-rule
reset traffic-statistic
inbound acl-rule
677
Description
-
-
-
Required
Type A I/O Modules support
this command.
Required
Non-type-A support this
command
Optional
You can execute the display
command in any view
Description
-
-
-
Required
Type-A I/O Modules support
this command.
Required
Non-type-A I/O Modules
support this command.