Displaying And Debugging Aaa And Radius Protocol - 3Com Switch 4500 26-Port Configuration Manual

218 C 11: 802.1X C
HAPTER
Displaying and
Debugging AAA and
RADIUS Protocol
ONFIGURATION
Table 238 Configure the RADIUS Server Response Timer
Operation
Configure the RADIUS server response timer
Restore the default value of the interval
By default, the response timeout timer for the RADIUS server is set to three
seconds.
After the above configuration, execute the
display the running of the AAA and RADIUS configuration, and to verify the effect
of the configuration. Execute the
RADIUS statistics. Execute the
and RADIUS.
Table 239 Displaying and Debugging AAA and RADIUS Protocol
Operation
Display the configuration information of
the specified or all the ISP domains.
Display related information of user's
connection
Display related information of the local user display local-user [ domain
Display the statistics of local RADIUS
authentication server
Display the configuration information of all
the RADIUS schemes or a specified one
Display the statistics of RADIUS packets
Display the stopping accounting requests
saved in buffer without response (from
System View)
Delete the stopping accounting requests
saved in buffer without response (from
System View)
Clear stop-accounting packets from the
buffer
Reset the statistics of RADIUS server
Enable RADIUS packet debugging
Disable RADIUS packet debugging
Command
timer response-timeout seconds
undo timer response-timeout
command in any view to
display
command in User View to reset AAA and
reset
command in User View to debug AAA
debugging
Command
display domain [ isp_name ]
display connection [ access-type {
dot1x | mac-authentication } |
domain domain_name | interface
interface_type interface_number |
ip ip_address | mac mac_address |
radius-scheme radius_scheme_name |
vlan vlanid | ucibindex ucib_index |
user-name user_name ]
isp_name | idle-cut { disable |
enable } | service-type { telnet |
ftp | lan-access | ssh | terminal }
| state { active | block } |
user-name user_name | vlan vlan_id ]
display local-server statistics
display radius [ radius_scheme_name
]
display radius statistics
display stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
reset stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
reset stop-accounting-buffer {
radius-scheme radius_scheme_name |
session-id session_id | time-range
start_time stop_time | user-name
user_name }
reset radius statistics
debugging radius packet
undo debugging radius packet