Displaying Engineering Units When Confirming Operation; Related Functions - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Displaying and Setting in Engineering Units

3-9-7 Displaying Engineering Units When Confirming Operation

Displaying Monitor ITEM Lists
Displays in Block Diagrams
Setting Engineering Units for Wireless Debugging

3-9-8 Related Functions

210
Engineering unit display and settings are enabled in the monitor ITEM list. The
notation is the same as for the ITEM list shown in 3-9-5 Displaying Function
Block ITEM Lists. In addition, when the monitor ITEM list is executed, ITEM data
transfer editing is enabled in engineering units.
Note For details on ITEM data transfers, refer to 4-6-2 Downloading Individual ITEM
Data Settings.
When checking operation in a block diagram, the ITEM values are displayed in
engineering units. The display can include integers, a decimal point, and a total
of up to five characters for the unit.
(Engineering Unit Display When Checking Operation)
If there is more information than can be displayed in the diagram, it can be
viewed in a tool chip when the cursor is over the function block, as shown below.
(Engineering Unit Display in Tool Chip Format)
Engineering units can also be set for forced changes to analog output signals
while checking function block operation.
Note For details on forced changes, refer to 4-6-5 Forced Changes to Analog Output
Signals.
Engineering units can be used for numeric inputs for wireless debugging.
Note For details on the wireless debugging function, refer to 4-6-4 Wireless Debug-
ging (LCBjj Ver. 3.0 or Later Only).
Print Preview and Printing
When the Engineering Unit Mode is enabled, data strings in the ITEM list are
printed in engineering units when the ITEM list is printed. The data strings are
displayed as right-justified engineering units shown with the units included (in
the same positions as in the ITEM list).
ITEM Setting Dialog Box for Segment Program 2 and Segment Program 3
Blocks
Section 3-9