Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual page 130

Creating Function Block
104
The flowing table lists the LCU/LCB numbers and corresponding Loop Con-
trollers.
Loop Controller
type
Loop Control
00-LCB01
Boards (LCB) ( C )
00-LCB05
00-LCB05-GTC
Loop Control p
01-LC001
Unit (LCU) U it (LCU)
02-LC001
03-LC001
Process-control 00-LCB05D
CPU Unit
Loop-Control
CJ1G-CPU42P
C U U CPU Unit
CJ1G-CPU43P
CJ1G-CPU44P
CJ1G-CPU45P
CJ1G-CPU45P-
GTC
Note a) One Loop Control Board, one Loop-control CPU Unit, and three
Loop Control Units can be registered per node.
b) A Loop Control Board can be registered and used at the same
time as a Loop Control Unit.
c) A Loop-control CPU Unit cannot be registered at the same time as
a Loop Control Board at the same node.
d) Always set the version that corresponds to the Loop Controller be-
ing used. If the incorrect version is set by mistake, use Change
LC Type from the Execute Menu to change the version number.
For details on methods used to confirm the Loop Controller ver-
sion, refer to Unit Version Notation on Products on page viii.
3. The project tree will be displayed in the Project Workspace.
• The node name will be automatically registered as "Node" + the node num-
ber (0 to 32). (See note.)
• The Block Diagram 1 function block group will be selected (highlighted) in
the project tree.
• The Block Diagram 1 function block group will be opened.
LCU/LCB Unit version
number
Version 1.00
or later
Version 1.00
or later
Version 3.00
---
Version 1.00
Version 2.00
or later
Version 2.00
or later
Version 2.00
or later
Version 2.00
or later
Version 3.00
Section 3-1
Model
CS1W-LCB01
CS1W-LCB05
CS1W-LCB05-GTC
CS1W-LC001
CS1D-CPUjjP
CJ1G-CPU42P
CJ1G-CPU43P
CJ1G-CPU44P
CJ1G-CPU45P
CJ1G-CPU45P-GTC