Editing Elements - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Creating Sequence Tables
Signal Output
form o
Output
Holding Output tab
command
classification:
OUT_H
(destination)
Non-holding Output tab
command
classification:
OUT_L
(destination)
Pulse Output tab
command
classification:
OUT_P
(destination)
Flashing Output tab
command
classification:
OUT_F
(destination)

3-8-7 Editing Elements

1, 2, 3...
202
Sequence table execute form
Setting
sc ee o screen on
C CX-Process
For Every Cycle (0) and Start on
Tool
Y: ON when the condition is met and remains ON
even when the condition is no longer met. Must
be turned OFF from another rule.
N: OFF when the condition is met and remains
OFF even when the condition is no longer met.
Must be turned ON from another rule.
Y: Remains ON while condition is
met and remain OFF while
condition is not met.
N: Cannot be specified.
Y: ON only once when condition is
met and turns OFF the next
operating cycle. The condition must
be not met and then met again
before the signal will turn ON again.
N: Cannot be specified.
Y: Changes between ON and OFF
when the condition is met and
continues flashing even when the
condition is no longer met.
N: The flashing output is turned ON
while the condition is met and
remains ON even when the
condition is no longer met.
Note: To turn OFF and output that
is being held ON, Use OUT_H with
an N specification. Even when this
is done, however, the signal will not
turn OFF until the condition for
OUT_F is no longer met (for both a
Y and N specification).
The following procedure must be performed in order to use timers and counters.
When editing the sequence table, Element must be selected in the Signal Dia-
log Box to display the elements set with this procedure and enable using them.
1. Right-click the sequence table and select View Mode/Element from the
pop-up menu to switch to Element Edit Mode.
(ITEM 006)
For Start
S1 (1) Only First
Cycle (2)
Cannot be
used.
Cannot be
used.
Cannot be
used.
Section 3-8
Y/N Execution
specification spec ca o condition co d o
in rule i
Y (ON) or N When
(OFF) condition
changes
from not
met to met
Only Y While
(always ON) condition is
met
Only Y (pulse When
output) condition
changes
from not
met to met
Y (flashing) While
or N (remains condition is
ON when met
flashing
stops)