Recovering Data From The Memory Card - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Transferring Tag and Comment Data

4-9-2 Recovering Data from the Memory Card

Inner Flash Memory
1, 2, 3...
Memory Card
1, 2, 3...
Recovery of data from inner flash memory can be performed only when perform-
ing a new upload.
1. Select the LCU/LCB element in the Project Workspace Area.
2. Perform a new upload.
3. Click the Start Button and data will automatically be transferred to the inner
flash memory after the function block data is transferred.
Recovery of data from a Memory Card can be performed only when a new
upload is performed. Use the following procedure.
1. Select the LCU/LCB element in the Project Workspace Area.
2. Perform a new upload.
3. The following dialog box will be displayed.
4. Click the Option Button and check that the Transfer data from Memory Card
option is selected. This option is normally selected by default when the
Memory Card is installed.
5. Click the Start Button. Function block data will be automatically transferred
from the Memory Card after being downloaded.
Note 1. If Memory Card backup is not required when the Memory Card is installed,
disable the option to transfer data from the Memory Card.
2. Use an OMRON Memory Card. Operations may be unstable if a non-
OMRON Memory Card (compact flash memory) is used.
File memory
Memory Card y
Note 1. A Memory Card can be written up to approximately 100,000 times. (Each
write operation to the Memory Card must be counted regardless of the size
of the write.) Be particularly careful not to exceed the life of the Memory Card
when writing to it from the ladder program.
Memory Memory capacity
type
Flash
15 Mbytes
memory
30 Mbytes
64 Mbytes
Section 4-9
Model
HMC-EF172
HMC-EF372
HMC-EF672
311