Version 4.1 - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Version Improvements

1-4-9 Version 4.1

Item
Installation method
Startup method
Folder for creating/saving projects Fixed location under
22
The improvements made from version 4.0 to version 4.1 of the CX-Process Tool
are listed in the following table.
Ver. 4.0
CX-Process Tool could
be installed as a single
entity only.
From the Start Menu
only
data folder in the
installation folder
Ver. 4.1
CX-Process Tool can be installed from the CX-One FA
Integrated Tool Package as one function.
If the CX-Process Tool is installed from the CX-One, a
dialog box to select the communications driver will not
be displayed when the CX-Process is started and the
CX-Server will be used automatically as the
communications driver.
Startup can be performed by right-clicking on any of the
following Loop Controllers under the I/O Table Window
of CX-Programmer that was installed from the CX-One,
and selecting Start Special Application.
• CS1W-LCB01 (Loop Control Board)
• CS1W-LCB05 (Loop Control Board)
• CS1D-LCB05D (Loop Control Board)
• CS1W-LC001 (Loop Control Unit)
• CJ1W-LCB01 (Loop Controller Element built into CPU
Unit)
• CJ1W-LCB03 (Loop Controller Element built into CPU
Unit)
Note If Start with Settings Inherited is selected,
CX-Server will be used automatically as the
communications driver. The node's Function
Block File will also be automatically created.
The user can specify the folder for creating/saving
projects.
Select File – New from the menu bar and specify the
destination in the Browse for Folder Dialog Box.
Section 1-4