Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual page 214

Creating Step Ladder Program Instructions
1, 2, 3...
188
When creating a program that is incompatible with ladder diagram format,
set the Mnemonic Flag (ITEM200) to 1 to disable automatic assembly and
disassembly by the CX-Process Tool. (This function is supported by Loop
Control Unit Version 2.50 and later versions, or LCBjjs.)
2. No syntax check will be made on the step ladder program instructions being
created in mnemonics. The step ladder programs will be transferred to the
Loop Controller as they are. A syntax check will be made on the step ladder
programs when the Loop Controller starts operating and any execution er-
rors will be stored in the Loop Controller. The error codes can be checked on
the Monitor Run Status Screen.
1. Select the Step Ladder Block and select Edit/Step Ladder Program from
the Settings Menu.
2. Click the icon or select Mnemonics from the Manipulate Ladder Menu.
The following screen will appear.
3. Take the following steps to input the instructions and operands from the key-
board.
a) Click Insert Row.
b) Double-click the Instruction Field.
c) Input the instruction. Example: LOAD
Note a) The instruction may be in lowercase or uppercase characters.
Section 3-7