Validating The Actions Of The Sequence Table; Printing The Sequence Table - Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual

Creating Sequence Tables

3-8-11 Validating the Actions of the Sequence Table

3-8-12 Printing the Sequence Table

206
• The block address specified for a TBL command does not exist.
A warning will be displayed while downloading a sequence table in the following
cases. Downloading will continue.
• A input signal is not registered in the reference table with the block address
specified for a TBL command in the main table.
• Y/N data is not registered in the reference table for the block address spe-
cified for a TBL command in the main table.
• An output signal is registered in the reference table.
• The block address specified for the TBL command is not set as a reference
table.
Right-click and select Validate Action/Start from the pop-up menu. The se-
quence table can be edited online during validation. Refer to 4-6-7 Validating
Sequence Table Operation for details.
Right-click and select Print/General from the pop-up menu.
Section 3-8