Omron WS02-LCTC1-EV5 - V5.2 REV 12-2008 Manual page 38

Relationship with CX-Process Monitor
Block to input analog signals from
the CX-Process Monitor Plus.
Blocks to monitor function
block ITEM tags from the CX-
Process Monitor Plus.
Set CSV Tags and Tags
for CX-Process Monitor
Plus.
1, 2, 3...
1, 2, 3...
Main function blocks
Blocks to manipulate or display contacts
from the CX-Process Monitor Plus.
Loop Control Units
1. Register the Send All Blocks block (Block Model 642) and Receive All
Blocks block (Block Model 641).
2. Set tags as follows:
• Function block data: Set CSV tags.
• Individual contact signals: Set CX-Process Monitor Plus tags for the con-
tacts in the Internal Switch block (Block Model 209).
• Individual analog signals from LCB element to computer: Set CX-Process
Monitor Plus tags for the analog signals in the Input Selection block (Block
Model 162).
• Individual analog signals from computer to LCB element: Set CX-Process
Monitor Plus tags for the analog signals in the Constant Generator block
(Block Model 166).
LCBjjs
1. Make the settings for the HMI in the System Common block (Block Model
000).
2. Set tags as follows:
• Function block data: Set CSV tags.
• Individual contact signals: Set CX-Process Monitor Plus tags for the con-
tacts in the Internal Switch block (Block Model 209).
• Individual analog signals from LCB element to computer: Set CX-Process
Monitor Plus tags for the analog signals in the Input Selection block (Block
Model 162).
• Individual analog signals from computer to LCB element: Set CX-Process
Monitor Plus tags for the analog signals in the Constant Generator block
(Block Model 166).
Note For any Loop Controller, the following function blocks must be
created and connected separately to enable monitoring and setting
individual contact signals and individual analog signals (i.e., other
than function block data).
Section
Block to output analog signals to
the CX-Process Monitor Plus.
1-2
11