Replacing Or Installing A Hard Disk - Intel D39172-003 User Manual

Hardware Installations and Upgrades

Replacing or Installing a Hard Disk

Important: An empty drive carrier (with baffle installed) MUST be fitted in ALL unused drive bays.
Note: At least one SATA hard disk with at least an 80-GB capacity must be installed before the
Caution: Before performing any maintenance on the system, back up the data. Shut down the
www.DataSheet4U.com
140
®
The Intel Entry Storage System SS4000-E allows for easy installation and replacement
of hard disks for any upgrade or repair. Refer to
Disks" for additional information on adding hard disks to or removing hard disks from
your system.
There will be inadequate drive cooling if any drive bays are left open.
storage system can be used. The Intel
any hard disks installed.
storage system by selecting the Advanced tab from the Manager and then Shutdown from
the left-hand menu.
1. Observe all safety and ESD precautions listed in
2. If you are unable to shut down the system using the software Manager then power
down the storage system by pressing and holding the power button for approximately
five seconds until the System Status LED starts flashing. The storage system will shut
off after a short shutdown period.
3. Disconnect the storage system from its power source.
Chapter 6, "Adding or Replacing Hard
®
Entry Storage System SS4000-E does not ship with
Appendix G, "Safety
Intel® Entry Storage System SS4000-E User Guide
Information".