Disabling Remote Boot - Intel D39172-003 User Manual

Protecting Local Disks

Disabling Remote Boot

www.DataSheet4U.com
112
5. Click Yes to allow the temporary network interruption. (Your network connection will
be restored immediately after this process is complete.)
On the Enable Remote Boot dialog box, the Details area shows the progress of the
enabling process. If any problems are encountered—for example, if the selected disk
or partition was not your system disk—that portion of the process is marked as
Failed. You can click the plus sign next to the process description to expand it and
display an error message that explains exactly what happened.
6. When a message appears, advising you that drivers will be installed, click OK.
7. When the drivers are installed, one or more messages might appear, advising you that
these drivers are not signed. This has no adverse effect on your system. Click
Continue Anyway or Yes on each message to proceed with the installation.
In addition, the Found New Hardware Wizard starts. Select No, Not this Time on the
initial screen and complete the rest of the wizard, accepting all the default values.
If remote boot was successfully enabled (as indicated in the Details area), a new
backup is created automatically.
Note: If remote boot was successfully enabled but for some reason the new backup
was not created (as indicated in the Details area), you must perform a manual
backup (as described in
can remotely boot only from backups that were performed after remote boot
was enabled.
8. Click Close.
If no problems were encountered, you can now remotely boot from the storage system
(as described in "Recovering a System Disk While Booting Remotely" on page
If any problems were encountered, take corrective action. For example, if you did not
previously protect a system disk or partition, do so now (as described in
Your Disks" on page
parts of the process complete successfully.
Disabling remote boot restarts your computer automatically. It is recommended that you
save and close any open files on your system before you do this.
To disable remote boot:
1. From the Action menu, click Disable Remote Boot.
A progress bar appears, indicating the progress of the process.
2. When the confirmation message appears, click OK.
Your computer restarts automatically.
"Manually Backing up Your Disk" on page
97). Then repeat this procedure for enabling remote boot until all
Intel® Entry Storage System SS4000-E User Guide
105). You
122.)
"Protecting