Figure 18. Rear View Of Sata Hard Disk; Figure 19. Installing Hard Disk Into Drive Carrier - Intel D39172-003 User Manual

Hardware Installations and Upgrades
Important: Make sure the hard disk is a SATA disk. It should have a SATA connector similar to the one
www.DataSheet4U.com
142
6. Remove the hard disk from its wrapper and place it on an anti-static surface.
illustrated in the following figure.

Figure 18. Rear View of SATA Hard Disk

7. With the hard disk circuit-side down, position the connector end of the new hard disk
so that it is facing the rear of the drive carrier. Align the holes in the new hard disk to
the holes in the drive carrier and attach the new hard disk to the carrier with the
screws that were removed in
Note: Be careful not to remove the side rail on the right-hand side of the drive
carrier. This rail contains the light pipe that displays the LED light on the
front of the drive carrier. In the event that the side rail comes loose, check to
ensure that the light pipe is properly inserted into the LED hole before
reattaching the side rail to the drive carrier.

Figure 19. Installing Hard Disk into Drive Carrier

AF000306
Step 5.
Intel® Entry Storage System SS4000-E User Guide
TP00929