Replacing Or Installing A Hard Disk - Intel SS4000-E - Entry Storage System NAS Server User Manual

Hardware Installations and Upgrades

Replacing or Installing a Hard Disk

The Intel
of hard disks for any upgrade or repair. see
for additional information on adding hard disks to or removing hard disks from your
system.
Important: An empty drive carrier with a baffle installed, MUST be fitted in ALL unused drive bays.
Cooling is inadequate if any drive bays are left open.
Note: At least one SATA hard disk with at least an 80-GB capacity must be installed. The Intel
Entry Storage System SS4000-E does not ship with any hard disks installed.
Caution: Before performing any maintenance, back up the data. Shut down the storage system by
selecting the Advanced tab from the Manager and then Shutdown from the left menu.
1. Observe all safety and ESD precautions listed in
2. If you are unable to shut down the system using the software Manager then power
down the storage system by pressing and holding the power button for approximately
five seconds until the System Status LED starts flashing. The storage system shuts off
after a short shutdown period.
Caution: Ensure the system is completely shutdown before removing the power chord.
3. Disconnect the storage system from its power source.
140
®
Entry Storage System SS4000-E allows for easy installation and replacement
Chapter 6, "Adding or Replacing Hard Disks"
Appendix H, "Safety
®
Intel Entry Storage System SS4000-E User Guide
®
Information".