Removing The Enclosure Cover; Figure 14. Removing Enclosure Cover - Intel D39172-003 User Manual

Hardware Installations and Upgrades

Removing the Enclosure Cover

Important: The cover should only be removed by qualified service personnel as it provides access to a
Note: Before performing any maintenance on the storage system, back up all data. Shut down
A
A
www.DataSheet4U.com
138
service area.
the storage system by selecting the Advanced tab from the Manager and then Shutdown
from the left-hand menu.
1. Observe all safety and ESD precautions listed in
2. If you are unable to shut down the system using the software Manager then power
down the storage system by pressing and holding the power button for approximately
five seconds until the System Status LED starts flashing. The storage system will shut
off after a short shutdown period.
3. Disconnect the storage system from its power source.
4. Remove the four screws at the back of the enclosure cover (see letter "A" in the
following figure). Slide the enclosure cover slightly rearward and then lift up (see
letter "B").
K

Figure 14. Removing Enclosure Cover

A
A
Intel® Entry Storage System SS4000-E User Guide
Appendix G, "Safety Information".
B
AF000231