Deleting A Backup - Intel D39172-003 User Manual

Managing Your Storage System

Deleting a Backup

Note: If you delete all backups of all disks for a particular computer, that computer no longer
www.DataSheet4U.com
56
computer's backup, enter the MAC address of the NIC of the computer that you want
to remotely boot in the MAC address text box.
Remote boot must have been previously enabled on that computer.
4. From the Backup for booting remotely list, select the time and date of the backup
that you want to remotely boot from.
To always boot from the most recent backup, select Latest backup.
An asterisk (*) identifies the backup that will be used for booting remotely.
Notes:
— You can remotely boot only from backups that were created after remote boot was
enabled on the client computer.
— If the selected backup is deleted to make room for newer backups, the most recent
backup will be used for booting remotely.
5. Click Apply Boot Info.
6. When the confirmation message appears, click OK.
If you changed the backup for booting remotely, an asterisk now appears next to the
selected backup.
You can delete all backups of a given disk, but you cannot delete just an individual backup
from a specific date and time.
appears on the Backups page. However, that computer name remains in the storage
system and counts toward the total number of computers that are allowed to back up to the
storage system. If you want to delete all backups of all disks and the computer name, refer
to "Deleting a Client" on page
To delete all backups of a disk:
1. In the navigation bar, click Backups.
2. Select the radio button adjacent to the disk whose backups you want to delete (in the
second Select column).
3. Click Delete Backup.
4. When prompted to confirm the deletion, click OK.
The disk no longer appears on the Backups page, and all backup versions are deleted.
If only one disk was protected, the computer name disappears from the page as well.
Note: If you delete a backup and the user did not previously remove protection for
that disk, when the user subsequently accesses Client Backup and Recovery,
the Status page will indicate that the backup of the protected disk is offline. To
back up the disk once again, the user must remove protection and then protect
57.
Intel® Entry Storage System SS4000-E User Guide