Figure 22. Re-Installing Drive Carrier Into Storage System - Intel D39172-003 User Manual

Hardware Installations and Upgrades
Important: Ensure that the drive carrier is orientated so that the hard disk is uppermost and the drive
Notes: If your hard drive was part of a RAID array previously, it will rebuild automatically.
www.DataSheet4U.com
144
9. With the black lever in the fully open position, insert the drive carrier into the storage
system. The green latch at the front of the drive carrier must be to the right of the
storage system. Do not push on the black drive carrier lever until the lever begins to
close by itself. Once the black drive carrier lever begins to close by itself, push on it to
lock the driver carrier into place.
carrier lever opens from the right. Also, do not force the drive carrier into the storage
system. If there is resistance, make sure that the drive carrier lever is in the fully open
position.
2
3
4

Figure 22. Re-installing Drive Carrier into Storage System

10. Reconnect the storage system to its power source.
11. Power up the storage system by pressing the power button on the front of the unit. The
System Status LED will flash while the system is booting up.
If you are replacing a failed hard disk in a RAID array, the Drive Status LED will blink
yellow until the array is rebuilt. Once the RAID is rebuilt, the Drive Status LED will turn
green indicating normal operation. If the RAID rebuild fails, the Drive Status LED will
1
2
Intel® Entry Storage System SS4000-E User Guide
TP02349