Error Message - Panasonic FZ-G2 Series Operating Instructions Manual

Error Message

Follow the instructions below when an error message appears. If the problem persists or if the error message is not shown here, contact Panasonic Tech-
nical Support.
Error Message
Bad System CMOS
System CMOS Checksum
Error
Invalid Year. System date
restored to 01/01/20XX
Press F2 for Setup / F12 for
LAN
Warming up the system (up to
30 minutes)
Remove disks or other media.
Press any key to restart
Reboot and Select proper
Boot device or Insert Boot
Media in selected Boot device
and press a key
Disk error Press any key to
restart
Please use the recommended
AC adaptor
Problem Undocking From Key-
board Base
An error has occurred in the memory of system settings. This occurs when the memory content is changed by an
unexpected program operation, etc.
Start the Setup Utility and return the settings to the default values, and then change the settings as neces-
l
sary.
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical
l
Support.
The date and time settings are not correct.
Start the Setup Utility and set the correct date and time.
l
If the problem persists, the internal clock battery may need to be replaced. Contact Panasonic Technical
l
Support.
Write down the error details and press ≪ F2≫ or ≪ Del≫ to start the Setup Utility.
l
Change the settings if necessary.
The computer is warming up before start up. Wait for the computer to start up (takes up to 30 minutes). If "Cannot
warm up the system" is displayed, the computer failed to warm up and does not start. In this case, turn off the com-
puter, leave it in an environment of 5 °C {41 °F} or higher temperature for about an hour, and then turn on the power
once more.
If a device is connected to the USB port, disconnect the device, or set [Tablet USB Port] or [Keyboard Base
l
and Cradle USB Port] to [Disabled] in the [Advanced] menu of the Setup Utility.
If the problem persists after removing the disk, it may be a flash memory failure. Contact Panasonic Tech-
l
nical Support.
The operating system is not properly installed in the flash memory that you are going to boot from.
If you cannot start up the OS from the internal disk, check if the internal disk is properly recognized on the
l
"Information" menu of the Setup Utility.
If it is recognized ("xxx GB" is displayed.), perform the reinstallation.
l
If not ("Empty" is displayed.), contact Panasonic Technical Support.
l
If a device is connected to the USB port, disconnect the device, or set [Tablet USB Port] or [Keyboard Base
l
and Cradle USB Port] to [Disabled] in the [Advanced] menu of the Setup Utility.
Use the specified AC adaptor.
l
Perform the following procedure.
1. Close the dialog box.
2. Remove peripheral devices connecting to the keyboard base, and then retry detaching the tablet from the
keyboard base ( Detaching the tablet from the keyboard
Solution
base).