Panasonic FZ-G2 Series Operating Instructions Manual page 157

The feedback noise may occur.
Keyboard
Only numbers can be input.
Only capital letters can be input.
Cannot enter special characters (ß, à, ç,
etc.) and symbols.
Network
Cannot connect to a network.
Cannot check the computer's MAC
address.
Wireless Communication (only for model with wireless LAN/Bluetooth/wireless WAN)
Cannot connect to a network.
To stop microphone's monitoring output.
l
1. Right-click
(Speakers) on the task tray, and click [Sounds].
2. Click [Recording] - [Microphone Array] - [Properties], and then remove a check mark
for [Listen to this device] in [Listen].
is on, the keyboard is in ten-key mode. Press ≪ Num Lock≫ to cancel.
When the indicator
l
When the indicator is on, the keyboard is in Caps Lock mode.
l
Press ≪ Caps Lock≫ to cancel.
Use the character map.
l
1. Click (Start) - [Windows Accessories] - [Character Map].
Set the device ([LAN] / [LAN (2nd)]
l
[Advanced] menu of the Setup Utility.
Follow the steps below.
l
1. Click (Start) -
2. Click [Network & Internet] - [Status] - [View hardware and connection properties].
Properties of each device appears.
Write down the 12-digit address (alphanumeric) that appears for "Physical address
(MAC):" rows of each devices.
The names of each of the devices are as follows.
Device
LAN
LAN (2nd)
Wireless LAN
Bluetooth
Wireless WAN
*The content displayed will vary depending on the device and model.
3. Click
to close the window.
Set the device ([Wireless LAN] / [Wireless WAN] of [Wireless Configuration]) to [Enabled] in the
l
[Advanced] menu of the Setup Utility (
Confirm the airplane mode is Off.
l
To turn off the airplane mode (
If this computer cannot be connected to an IEEE802.11a network, confirm
l
the Wireless LAN Standard IEEE802.11a
Restart the computer.
l
/ [Wireless LAN] / [Wireless WAN]) to [Enabled] in the
(Settings).
Connection name
Ethernet
Ethernet 2
Wi-Fi
Bluetooth Network Connection
Cellular
Wireless Configuration).
Using airplane mode).
(802.11a)".
"Enabling/Disabling