Installing Software - Panasonic FZ-G2 Series Operating Instructions Manual

Installing Software

Installing software will return the computer to the default condition. When you install the software, the internal SSD data will be erased.
Back up important data to other media or an external flash memory before installation.
I M P ORTANT
Do not delete the recovery partition on the SSD. If it has been deleted, the recovery disc could not be created.
l
To check the recovery partition, perform the following methods.
1. Right-click
A standard user needs to enter an administrator password.
l
Disk recovery
You can reinstall the OS that was pre-installed at the time of purchase.
I M P ORTANT
If the recovery partition is deleted, you cannot perform flash memory recovery.
l
If reinstallation using the method described in "Reset this PC" is not successful, follow the steps below.
Preparation
Remove all peripherals.
l
Connect the AC adaptor and do not remove it until installation is complete.
l
1. Start the Setup Utility.
1. Click
(Start) -
2. Click [Restart now] under "Advanced startup".
3. Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
2. Write down all of the contents of the Setup Utility and press ≪ F9≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
3. Press ≪ F10≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
The computer will restart.
4. Press ≪ F2≫ or ≪ Del≫ while "Panasonic" boot screen is displayed.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
l
NOTE
For the tablet only, touch the top left corner of the screen or press the
l
screen is displayed.
5. Select the [Exit] menu, then select [Recovery Partition] and press ≪ Enter≫ .
Computer will restart.
6. Click [Recovery].
Click [CANCEL] to abort the operation.
(Start) - [Disk Management].
(Settings) - [Update & Security] - [Recovery].
button while "Panasonic" boot