Table of Contents
Advertisement
Troubleshooting
Error Message
Follow the instructions below when an error code or message appears. If the problem persists or if the error
code/message displayed is not shown here, contact your technical support office.
Error
Bad System CMOS
System CMOS Checksum Error
Invalid Year. System date restored
to
01/01/20XX
Error
Hard disk access is prohibited by
"Hard Disk Lock"
Press <F2> to enter setup
Reboot and Select proper Boot
device or Insert Boot Media in
selected Boot device and press
a key
Disk error
Press any key to restart
Starting the Setup Utility: page 49
An error has occurred in the memory of system settings. This occurs
when the memory content is changed by an unexpected program
operation, etc.
•
Start the Setup Utility and return the settings to the default values,
and then change the settings as necessary.
•
If the problem persists, the internal clock battery may need to be
replaced. Contact your technical support office.
The date and time settings are not correct.
•
Start the Setup Utility and set the correct date and time.
•
If the problem persists, the internal clock battery may need to be
replaced. Contact your technical support office.
•
Run the Setup Utility, and set [Hard Disk Lock] to [Disabled].
•
Write down the error details and press
Setup Utility. Change the settings if necessary.
The computer cannot be booted from the floppy disk or the hard disk.
•
Remove the floppy disk drive.
•
Confirm [Hard Disk] of [Information] menu in the Setup Utility.
•
If [xxx GB] is displayed, reinstall Windows.
•
If [None] is displayed, contact your technical support office.
•
Remove the USB device or set [Legacy USB Port] to [Disabled] in
the Setup Utility.
Message Solution
or
to start the
89
Advertisement
Table of Contents
Troubleshooting
