Panasonic FZ-G2 Series Operating Instructions Manual page 72

Removing a nanoSIM card
1. Turn off the computer and disconnect the AC adaptor.
2. <For tablet> Turn your computer over.
Make sure no foreign objects are under the computer.
3. Remove the battery pack. (
<Only for model with Built-in Bridge Battery>
Wait for about 3 minutes.
l
4. Remove the SSD pack. (
5. Remove the screws (D) and the nanoSIM card slot cover (E).
Use the PH 0 (PH #0) screwdriver.
6. Push the nanoSIM card (F).
It will come out of the slot a little bit.
7. Pull the card all the way out.
8. Close the nanoSIM card slot cover (E), attach it and tighten the screws (D) firmly.
Use the PH 0 (PH #0) screwdriver.
Use 2 screws.
Recommended tightening torque
0.2 N•m ± 0.02 N•m (2.0 kgf•cm ± 0.2 kgf•cm)
9. Insert the SSD pack and battery pack.
10. Connect the AC adaptor.
eSIM/nanoSIM Switching
<Only for the wireless WAN module EM7511/EM9190 that supports eSIM>
1. Click (Start) -
2. Click [Cellular].
3. Click [SIM 1] or [SIM 2] under "Use this SIM for cellular data".
[SIM 1]: nanoSIM
[SIM 2]: eSIM
<Only for the wireless WAN module EM7455/EM7430 that supports eSIM>
1. Click (Start) -
2. Click [eSIM] or [nanoSIM card] in "SIM" under "eSIM Settings".
Wait a moment for the settings to switch.
Replacing the Battery Pack)
Attaching/Detaching the SSD
(Settings) - [Network & Internet].
(Panasonic PC Settings Utility) -
Pack)
(Settings) - (Network).