Panasonic FZ-G2 Series Operating Instructions Manual page 71

[Advanced] menu of the Setup Utility.
If "Device driver software was not installed correctly." (or a similar message) appears when starting the computer or resum-
l
ing from sleep or hibernation.
When communication works normally, Wireless WAN is operating correctly.
l
If communication fails, the device may not be recognized correctly. In this case, restart the computer.
l
Do not use the nanoSIM card adapter.
l
Do not insert nanoSIM cards on which labels or stickers are affixed. Failure to obey may result in malfunction.
l
Inserting/Removing a nanoSIM Card
<Only when using a nanoSIM card>
Before using the Wireless WAN, set a nanoSIM card to the nanoSIM card slot.
I M P ORTANT
Be sure to turn off the computer before inserting or removing the nanoSIM card.
l
Inserting a nanoSIM card
1. Turn off the computer and disconnect the AC adaptor.
2. <For tablet> Turn your computer over.
Make sure no foreign objects are under the computer.
3. Remove the battery pack. (
<Only for model with Built-in Bridge Battery>
Wait for about 3 minutes.
l
4. Remove the SSD pack. (
5. Remove the screws (A) and the nanoSIM card slot cover (B).
Use the PH 0 (PH #0) screwdriver.
6. Insert the nanoSIM card (C) into the nanoSIM card slot.
I M P ORTANT
Do not insert the nanoSIM card upside down.
l
7. Close the nanoSIM card slot cover (B), attach it and tighten the screws (A) firmly.
If the cover is not closed, the nanoSIM card may jump out when the computer falls.
l
Use the PH 0 (PH #0) screwdriver.
Use 2 screws.
Recommended tightening torque
0.2 N•m ± 0.02 N•m (2.0 kgf•cm ± 0.2 kgf•cm)
8. Insert the SSD pack and battery pack.
9. Connect the AC adaptor.
Replacing the Battery Pack)
Attaching/Detaching the SSD Pack)