Panasonic FZ-G2 Series Operating Instructions Manual page 81

NOTE
Set the key entry mode to English ("ENG") and enter characters.
l
The keyboard layout can be added or changed in the following steps.
1. Click
(Start) -
2. Click a language and click [Options].
3. Click [Add a keyboard] and choose a keyboard from the list.
Remember your password. If you forget the password, you cannot use Windows. Creating a password reset disk before-
l
hand is recommended.
Preventing Your Computer from Unauthorized Use
You can set a start-up password to protect your computer from unauthorized use.
1. Set the password (
On Resume] in the [Security] menu of the Setup Utility.
NOTE
The [Password On Resume] of Setup Utility is effective when the computer was once shut down, and not effective when
l
the computer resume from sleep.
If the Supervisor Password or User Password has been set, the password input screen will be displayed on starting-up of
l
the Setup Utility even though [Password On Boot] and/or [Password On Resume] is set to [Disabled]. If you set [Password
On Boot] to [Enabled] and set [Password on Reboot] to [Same as Boot], password input will also be required at Windows
restart. ([Same as Boot] is the default setting.)
Preventing Your Flash Memory Drive from Being Read or Written
The flash memory lock function protects the flash memory data from being read or written when the flash memory is attached to another computer. The
data can be read/written when the flash memory is returned to the original computer. (Note that the flash memory lock does not guarantee complete pro-
tection of the data.)
1. Select [Set Storage Password] in the sub-menu of [Storage Security Configuration (TCG)] in the [Security] menu of the Setup
Utility.
2. Enter your password in [Create New Password] and press ≪ Enter≫ .
When the password has been set, you need to enter your password in [Enter Current Password] and press ≪ Enter≫ .
l
To disable the password, leave the input field empty and press ≪ Enter≫ .
l
3. Enter your password again in [Confirm New Password] and press ≪ Enter≫ .
I M P ORTANT
You cannot use the flash memory lock function without setting the Supervisor Password. Set the Supervisor Password
l
beforehand ( Setting the Supervisor Password/User
When you have your flash memory drive repaired.
l
Contact Panasonic Technical Support.
l
Before sending back the flash memory drive, be sure to disable the Storage Password and Supervisor Password.
l
NOTE
The password will not be displayed on the screen.
l
If the [Caution] screen appears when entering the password, check the status of Num Lock and Caps Lock.
l
You can use up to 32 alphanumeric characters (including spaces).
l
(Settings) - [Time & Language] - [Language].
Setting the Supervisor Password/User Password), and select [Enabled] in
Password).
[Password On Boot] and/or [Password