Using Recovery Disc - Panasonic FZ-G2 Series Operating Instructions Manual

7. Confirm the contents of "EULA", and click [Accept.] if you continue.
8. Click [Integrated Storage Drive : xxxx] or [Quick Release Storage Drive : xxxxx].
9. Click [Recovery ALL Partitions.].
Installation starts according to the instructions on the screen. (It will take approximately several tens of minutes.)
Do not interrupt installation, for example by turning off the computer or performing other operation. Otherwise installation may become
l
unavailable as Windows may not start up or the data may be corrupted.
10. When the Ending process screen is displayed, click [Shutdown.] to turn off the computer.
11. Turn on the computer.
If the password is requested, enter the Supervisor Password.
l
12. Perform Setup Windows (
13. Start the Setup Utility and change the settings as necessary.
14. <Only for model with TPM> Clear TPM.
1. Right-click
2. Click [Clear TPM...] under "Actions" on the right of the "Trusted Platform Module (TPM) Management on Local Computer" screen.
3. Click [Restart] of the "Manage the TPM security hardware" screen.
4. After restarting the computer, perform the step 1 to display the "Trusted Platform Module (TPM) Management on Local Computer"
screen.
After restarting the computer, the "Trusted Platform Module (TPM) Management on Local Computer" screen may appear
l
automatically.
5. Click [Refresh] under "Actions" on the right of the "Trusted Platform Module (TPM) Management on Local Computer" screen.
6. When "The TPM is ready for use." appears in "Status" item, close the "Trusted Platform Module (TPM) Management on Local Com-
puter" screen.
If "The TPM is ready for use." does not appear, wait a moment and click [Refresh] again.

Using Recovery Disc

Use the Recovery Disc in the following conditions.
You have forgotten the administrator password.
l
Installation is not complete. The recovery partition in the flash memory may be broken.
l
Preparation
Prepare the following items:
l
Recovery Disc (USB memory device can also be used as a recovery disc.) (
l
Commercially available optical drive
l
Remove all peripherals (except for the commercially available optical drive).
l
Connect the AC adaptor and do not remove it until installation is complete.
l
1. Start the Setup Utility.
1. Click
(Start) -
2. Click [Restart now] under "Advanced startup".
3. Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
2. Write down all of the contents of the Setup Utility and press ≪ F9≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
3. Insert the media that was used to create the recovery disc.
OPERATING INSTRUCTIONS - Read Me First).
(Start) - [Run], then input "tpm.msc" and click [OK].
(Settings) - [Update & Security] - [Recovery].
Create a Recovery Disc)