Panasonic FZ-G2 Series Operating Instructions Manual page 164

If the touchpad does not operate properly, press ≪ Ctrl≫ + ≪ Alt≫ + ≪ Del≫ to restart the computer, or press the power
l
switch to turn the power off, and then restart the PC-Diagnostic Utility.
Running the Diagnostic Check
Run this utility using the default settings in the Setup Utility.
If the Setup Utility or other settings will not allow hardware to be executed, the hardware icon will be displayed in gray.
1. Connect the AC adaptor, and be enabled the wireless function.
During the diagnostic check, do not remove the AC adaptor, or attach any peripheral devices.
2. Start the Setup Utility.
1. Click (Start) -
2. Click [Restart now] under "Advanced startup"
3. Click [Troubleshoot] - [Advanced options] - [UEFI Firmware Settings] - [Restart].
The computer restarts, and the Setup Utility screen appears.
If the password is requested, enter the Supervisor Password.
l
If you are using the computer after changing the settings from the status at the time of purchase, we recommend that you make a note
l
of the settings that are changed.
*2 : Screen messages are explained in [English (United States)].
(Depending on the language preference, some screen messages in these instructions are different from the actual screen messages. For
example, [Advanced start-up] may be displayed instead of [Advanced startup] in some language preference.)
3. Press ≪ F9≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
4. Press ≪ F10≫ .
At the confirmation message, select [Yes] and press ≪ Enter≫ .
The computer will restart.
5. Press ≪ F2≫ or ≪ Del≫ while "Panasonic" boot screen is displayed.
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
l
NOTE
For the tablet only, touch the top left corner of the screen or press the
l
screen is displayed.
6. Select the [Exit] menu, and then select [Diagnostic Utility].
When the PC-Diagnostic Utility starts up, it will automatically begin the diagnostic check for all hardware components.
If the password is requested, enter the password.
l
The touchpad and the internal keyboard may not be used when each hardware checking is running. While checking is in process, a ver-
l
tical green progress bar (A) is displayed on the right side of the hardware icon.
You can perform the following operations by selecting the icons on the screen:
l
l
l
(Settings) - [Update & Security] - [Recovery].
*2
: Start the diagnostic check from the beginning.
: Stop the diagnostic check (After the process is stopped, you cannot resume it by selecting
.
button while "Panasonic" boot
).