Selecting Transport Protocols - Xerox WorkCentre 7132 System Administration Manual
Print copy scan fax email
Hide thumbs
Also See for WorkCentre 7132:
- Service documentation (1726 pages) ,
- User manual (468 pages) ,
- Quick network setup manual (73 pages)
Table of Contents
Advertisement
If the test fails, refer to the Problem Solving chapter for assistance.
NOTE: If the Auditron feature is enabled, you may be required to enter the user ID
and password (if one is set up). If you need assistance, contact the Key Operator.
NOTE: When your access to CentreWare Internet Services is encrypted, enter
"https://" followed by the internet address, instead of "http://".
Selecting Transport Protocols
When using the NetWare, SMB, or SNMP port, change the transport protocol if
required.
• NetWare: IPX/SPX, TCP/IP
• SMB: NetBEUI, TCP/IP
• SNMP: UDP, IPX
1.
At the CentreWare Internet Services home page for the machine, select the
[Properties] tab.
2.
In the [Properties] frame, select [Port Status].
3.
Select the required transport protocol.
NetWare: IPX/SPX, TCP/IP
SMB: NetBEUI, TCP/IP
SNMP: UDP, IPX
4.
Select [Apply].
Xerox WorkCentre 7132 System Administration Guide
Selecting Transport Protocols
49
Advertisement
Table of Contents
Troubleshooting
