10 Usb Port; Information Checklist - Xerox WorkCentre 7132 System Administration Manual

10 USB Port

This chapter explains how to set up the machine in a USB port environment. The
following information is provided.
Information Checklist – page 109
USB Port Environment – page 110
USB Port Installation – page 110
Installation Procedure – page 110
USB Port Communication Setup – page 111
Workstation Setup – page 111
Test Print – page 112

Information Checklist

Before starting the USB port installation procedures, make sure that the following items
are available or have been performed.
USB Cable
Test the machine to make sure that it is installed fully and functioning
correctly.
Install the print driver.
NOTE: The installation procedures will install the machine on the USB port of the host
workstation. The procedures are not intended to connect the host workstation to other
workstations.
If problems are encountered during the installation of the machine, refer to the Problem
Solving chapter for assistance.
CAUTION: Do not connect the USB cable to the machine until instructed to do
so.
Xerox WorkCentre 7132 System Administration Guide
Item By
Customer
Customer
Customer
109