Restrictions - Xerox WorkCentre 7132 System Administration Manual

15 Problem Solving

Restrictions

This section explains the restrictions that apply while using SMB.
Machine settings
• The IP address is a unique address administered system-wide. Consult with the
network administrator when setting the necessary parameters.
• The subnet mask and gateway settings may also be required, depending on the
networking environment. Consult with the network administrator when setting the
necessary parameters.
• When a port status is enabled and there is insufficient memory, the port status may
be disabled automatically. In this case, disable all unused ports and reallocate the
memory.
• The [Receiving Buffer - SMB Spool] memory allocation needs to be set in response
to the operating environment. If the memory allocation is too small, it may prevent
receiving messages.
Client settings
• The IP address is a unique address administered system-wide. Consult with the
network administrator when setting the necessary parameters.
• Consult with the Network Information Service (NIS) administrator when setting up
the network parameters (IP address and other parameters) from a host running NIS.
When the machine is switched off
The following actions take place when the machine is switch off.
• When [Receiving Buffer - SMB Spool] is set to [Memory]:
All print data spooled in machine memory, including the data currently being printed,
is deleted. There is no print data on the machine when the machine is subsequently
switched on.
However, if the machine is switched off immediately after a print request, the print
data may be stored on the client. In this case, the print request can be reissued when
the machine is subsequently turned on, and the print data is printed on the machine
in turn.
• When [Receiving Buffer - SMB Spool] is set to [Hard Disk]:
All print data spooled on the machine hard disk, including the data currently being
printed, is retained. A print request can be reissued when the machine is
subsequently turned on, and the print data is printed on the machine in turn.
• When [Receiving Buffer - SMB Spool] is set to [Off]:
All print data in the receiving buffer, including the data currently being printed, is
deleted. There is no print data on the machine when the machine is subsequently
switched on.
However, if the machine is switched off immediately after a print request, the print
data may be stored on the client. In this case, the print request can be reissued when
146 Xerox WorkCentre 7132 System Administration Guide