Table of Contents
Advertisement
is
CHAPTER 3 MECHANICAL SYSTEM
ml
4)
Remove pressure cam home position sensor
4)
Remove cap cam home position sensor @.
Figure 3-306
Figure 3-304
6. Removing the Wiper Solenoid
5. Removing the Cap Cam Home
1) Move the carriage to the center of the platen.
Position Sensor
2) Remove the right and right rear covers.
1) Remove the right and right rear covers.
3) Remove 2 wiper blades.
2)
Remove the pre-discharge tank and waste ink
4) Disconnect 2-pin relay connector @ from wiper
tank. (See page 3-26.)
solenoid 2.
3)
Remove the 2 hooks to remove sensor instal-
lation plate @.
Wo
otf
Wr
hi
i
Figure 3-307
Figure 3-305
Advertisement
Table of Contents
