Procedure After Replacing The Cs; Reader Home Position Sensor; Removing The Reader Home Position Sensor - Canon MF6500 Series Service Manual

Chapter 3
[1]
4) Holding the belt, move the contact sensor unit to the cutout [1] in the
reader frame.
5) Remove the cable holder [2] and flexible cable [3] to remove the contact
sensor [4].
[1]
[3] [2]

3.4.4.2 Procedure after Replacing the CS

LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
After replacing the contact sensor (CS), go through the following steps to
perform inter-channel output correction:
1) Enter the service mode.
Sequentially press the Additional functions key, 2 key, 8 key, and Additional
functions key on the operation panel.
2) Press the arrow key on the touch panel to display "TEST MODE".
3) Press [OK].
4) Press the [2] key to display "SCAN TEST".
5) Press the [1] key to display "SHADING".
6) Press [OK].
After completion of the above procedure, the contact sensor output is
compensated and parameters are set automatically.
After completion of automatic adjustment, "OK" is displayed.

3.4.5 Reader Home Position Sensor

3.4.5.1 Removing the Reader Home Position Sensor

LaserBase MF6530 / / LaserBase MF6540PL / LaserBase MF6550 / Kaser-
Base MF6560PL / / LaserBase MF6580PL
1) Remove the copyboard glass.
2) Remove one screw [1] and release the two claws [2] to remove the jump
mount [3].
3) Remove the reading glass [4].
3-6
Download Free Service Manual And Resetter Printer at http://printer1.blogspot.com
[2] [1]
F-3-13
[4]
F-3-14
4) Taking care not to break the hook, remove the home position sensor [1]
with a flathead screwdriver. Next, disconnect the connector [2]. If the
contact sensor unit is over the reader home position sensor, move the
contact sensor unit to an appropriate position by holding the belt [3].
0012-7426
0011-5283
[4]
[1]
[3]
[2]
F-3-15
[2]
[1]
[3]
F-3-16