Table of Contents
Advertisement
PCB
1) Remove the seven mounting screws @ and
remove the expansion cover @).
O
Figure 3-703
CAUTION
When the image controller is installed,
secure the connector to the engine control-
ler PCB.
Figure 3-701
CAUTION
Before starting the procedure, make sure
PCB at the image controller PCB side.
1)
Remove the rear cover. (Refer to page 3-2 and
3-3).
2) Remove the two mounting screws © at the
interface connection section.
1
5}
9)
Figure 3-702
3) Disconnect the two connectors @ and remove
the eleven mounting screws © on the image
controller PCB.
Figure 3-704
COPYRIGHT © 1998 CANON INC.
3-47
Advertisement
Table of Contents
