Table of Contents
Advertisement
6) Remove the mounting screw and remove the
tube cover.
Figure 1-808
7)
Remove the four ink supply tubes and the one
connector.
Connector
Figure 1-809
CAUTION
When removing the connector, make sure
that the connector is the side of ink botlle
case.
After the checking that the ink in the tube
return to the buffer section, remove the ink
supply tubes.
8)
Insert the pin into the end of the removed
supply tube.
(0
(ae)
es sere
GES aes ae
GD)
a
wre
Figure 1-810
COPYRIGHT © 1998 CANON INC.
CHAPTER 1 GENERAL INTRODUCTION
mm
CAUTION
The pin might not be extractable if it is fully
inserted into the tube.
9) Attach the joint cap on the joint section of the
ink bottle case.
——
Joint cap
Figure 1-811
10) Remove the two mounting screws and remove
the ink bottle case from the printer body.
Screw
Ink bottle case
Figure 1-812
11) Remove the all ink bottties from the ink bottle
case. Put a cap on each removed ink bottle.
12) Remove the four tube guides, using screw-
driver.
Figure 1-813
1-41
Advertisement
Table of Contents
